Dalian qianda trading co. LTD
Associate: manager li
Associate: manager pu
Web site: www.dlqianda.com
tongren street, xigang district, dalian city, liaoning province
At present, most of the domestic wax printing production USES vertical two - sided circular net wax printing machine. After the wax material is heated and boiled, it turns into a slurry of wax liquid, which is then pumped through the heat pipe into the nickel round net plate. The two same round web plates rotate in the opposite direction, and at the same time, the paraffin fluid is scraped to form the opposite printing, so that the same wax pattern is obtained on the front and back of the fabric. The wax pattern on the fabric can be cooled into a film by spraying in cold water or passing through the cooling water tank.
After dyeing with indigo, the waxed fabric can achieve the same effect of double-sided printing on the front and back. Subsequently, the printing wax fabric enters the waxing process,), and the waxing cracks generated by the waxing wax do not have the anti-dyeing effect, which can be colored in the subsequent waxing process. True wax has two main functions in wax printing: one is to act as anti-dyeing agent, and the other is to produce fine wax patterns. This requires that the wax film on the fabric not only has a certain degree of toughness, in order to obtain a good anti-dyeing effect; It also needs good brittleness to obtain rich fine wax patterns.
Water recovery dewaxing is often used in precision casting wax production. The dewaxing effluent flows through several sedimentary ponds successively. Through multi-stage filtration and long-term static settlement, the waxy microcrystalline particles suspended in the water are gradually condensed into milk and deposited at the bottom of the pool. After being the bottom reaches a certain thickness of the recovered wax, removed to boiling wax slot or heated and help, if necessary can be the first of the reentry after natural air boiled, in order to improve the heating efficiency and reduce energy consumption. The recovery process is time-consuming and laborious, and the recovery cycle is long.
In order to reduce the cost of wax printing and improve the properties of wax, especially the toughness and brittleness of wax film, different waxes or wax solutions are often mixed, mainly new wax and recycled wax. The higher the ratio of recycled wax, the lower the cost of wax printing. Due to the repeated recovery, boiling and reuse of the old wax, the waxy properties of the old wax are gradually degraded, which is mainly manifested in the increase of brittleness and the decrease of flexibility. Therefore, too high proportion of the old wax will affect the quality of wax printing.
At present, the old wax ratio of each wax printing manufacturer is generally controlled at 40%~60%, the actual production also depends on the old wax recovery rate of each manufacturer. For some special types of wax printing, the proportion of new wax should be increased.